Choose the burden resistor for a current transformer feeding a microcontroller ADC. Enter the CT ratio and the maximum primary current; the calculator sizes the burden so the waveform peak fits the ADC range with 10% headroom.

Formula

Rburden = Vpeak,allowed / (√2 × Iprimary,max / N)

With a mid-rail bias the allowed peak is half the ADC reference; with a grounded burden it is the full reference, but you only sample the positive half-cycle.

Design notes

  • Stay below the CT’s rated burden, or it will saturate and read low at high current.
  • Never leave a loaded CT secondary open. Large external CTs (for example 200:5 A) can produce dangerous voltages with the burden removed.
  • Add a series resistor and a small capacitor at the ADC pin to limit current and filter noise.
  • Calculate RMS from samples over a whole number of mains cycles, and calibrate gain in firmware.

More calculators

Need this designed for your product? We design power electronics, embedded firmware and industrial IoT hardware. Message us on WhatsApp or use the contact form.