Type the code printed on an SMD resistor to get its value. Works with 3-digit, 4-digit, R-decimal and EIA-96 codes.
How SMD resistor codes work
- 3-digit: first two digits are the value, the third is the number of zeros. 103 = 10 × 10³ = 10 kΩ; 472 = 4.7 kΩ.
- 4-digit: first three digits plus a multiplier, used for 1% parts. 1002 = 10.0 kΩ.
- R notation: R is the decimal point. 4R7 = 4.7 Ω, R10 = 0.1 Ω (common for current-sense shunts).
- EIA-96: two digits pick a value from the E96 table and a letter sets the multiplier. 01C = 100 × 100 = 10 kΩ.
Through-hole part? Use the resistor colour code calculator. To confirm a value on the board, see how to test components with a multimeter.
More calculators
- PCB Trace Width Calculator (IPC-2221)
- Voltage Divider and ADC Scaling Calculator
- LED Series Resistor Calculator
- Battery Backup Time Calculator for Inverters and UPS
- CT Burden Resistor Calculator for Microcontroller ADC
- Ohm’s Law and Power Calculator
- Resistor Colour Code Calculator (4 and 5 Band)
- 555 Timer Astable Calculator
- RC Time Constant and Cut-off Frequency Calculator
- IPS / Inverter Size and Battery Calculator for Home
- Electricity Unit (kWh) and Bill Calculator
- Solar Home System Size Calculator (Panels, Battery, Controller)
- Capacitor Code Calculator (104, 103, 222 to nF and µF)
- Series and Parallel Resistor and Capacitor Calculator
- Wire Size and Voltage Drop Calculator (mm² Cable)
- LM317 Voltage Regulator Calculator (R1, R2 and Output Voltage)
- Buck Converter Calculator (Duty Cycle, Inductor and Capacitor)
- Battery Charging Time Calculator (Lead-Acid, Li-ion, LiFePO4)
- Li-ion / LiFePO4 Battery Pack Calculator (Series and Parallel Cells)
- Op-Amp Gain Calculator (Inverting and Non-Inverting)
- kVA, kW and Amps Calculator (Single-Phase and Three-Phase)
Need this designed for your product? We design power electronics, embedded firmware and industrial IoT hardware. Message us on WhatsApp or use the contact form.