Enter your buck converter specs to get duty cycle, inductor value, peak switch current and output capacitance for your ripple target.
Formulas used (ideal, continuous mode)
- D = Vout / Vin (real converters need slightly more because of losses).
- L = (Vin − Vout) × D / (fsw × ΔI), with ΔI chosen as 20–40% of output current.
- Ipeak = Iout + ΔI/2: pick an inductor whose saturation current is comfortably above this.
- Cout ≈ ΔI / (8 × fsw × ΔV) for the capacitive part of the ripple; ESR adds ΔI × ESR on top.
Building one? Read our buck converter with a low-side MOSFET and the MPPT synchronous buck guide.
More calculators
- PCB Trace Width Calculator (IPC-2221)
- Voltage Divider and ADC Scaling Calculator
- LED Series Resistor Calculator
- Battery Backup Time Calculator for Inverters and UPS
- CT Burden Resistor Calculator for Microcontroller ADC
- Ohm’s Law and Power Calculator
- Resistor Colour Code Calculator (4 and 5 Band)
- 555 Timer Astable Calculator
- RC Time Constant and Cut-off Frequency Calculator
- IPS / Inverter Size and Battery Calculator for Home
- Electricity Unit (kWh) and Bill Calculator
- Solar Home System Size Calculator (Panels, Battery, Controller)
- SMD Resistor Code Calculator (3-Digit, 4-Digit and EIA-96)
- Capacitor Code Calculator (104, 103, 222 to nF and µF)
- Series and Parallel Resistor and Capacitor Calculator
- Wire Size and Voltage Drop Calculator (mm² Cable)
- LM317 Voltage Regulator Calculator (R1, R2 and Output Voltage)
- Battery Charging Time Calculator (Lead-Acid, Li-ion, LiFePO4)
- Li-ion / LiFePO4 Battery Pack Calculator (Series and Parallel Cells)
- Op-Amp Gain Calculator (Inverting and Non-Inverting)
- kVA, kW and Amps Calculator (Single-Phase and Three-Phase)
Need this designed for your product? We design power electronics, embedded firmware and industrial IoT hardware. Message us on WhatsApp or use the contact form.