How to Test Electronic Components with a Multimeter (Resistor, Diode, Capacitor, Transistor)
Learn how to test resistors, diodes, LEDs, capacitors, transistors and MOSFETs with a digital multimeter, with the readings a good part should show.
Analog-to-digital conversion and measurement: reading voltage, current and sensors accurately with microcontroller ADCs.
Learn how to test resistors, diodes, LEDs, capacitors, transistors and MOSFETs with a digital multimeter, with the readings a good part should show.
Measure three-phase mains voltage with PTs and a microcontroller: scaling a 220:12 V PT for a 3.3 V ADC, line-to-line RMS, phase failure and phase sequence detection.
How to measure AC current with a current transformer and an STM32 or ESP32 ADC: burden resistor sizing, mid-rail biasing, true RMS code and calibration.
Some links in this article are affiliate links. If you buy through them, LabprojectsBD may earn a small commission at no extra cost to you. In this article 🔥 First Look – Modern Multimeter for Modern Engineers ⚠️ Important: How Auto Mode Works (Very Important for Buyers) ⚙️ Core Features Read more
A digital and analog trainer kit is a fundamental requirement for electronics education. Engineering students must understand both analog signal behavior and digital logic systems to build real-world electronic products. However, learning these concepts without proper laboratory hardware often limits practical understanding. ⏱ 3 min read · 🔧 Includes: diagrams Read more
Operational amplifiers are one of the most fundamental building blocks in analog electronics. From signal conditioning to oscillators and filters, op-amps are used in almost every electronic system. However, students often struggle to understand op-amp behavior without hands-on experimentation. In this article Purpose of This Op-Amp Trainer Kit Built-in Op-Amp Read more
In this chapter, we’ll focus on Learning ADC of PIC microcontrollers. ADC or Analog to Digital Converter is one of the most fundamental features of a microcontroller. And whenever we work with microcontrollers, we need this feature almost all the time. So we have to learn it which is a Read more
In this chapter, we will learn How to interface buttons with microcontrollers. This is another basic part of the series of Learning PIC microcontrollers in C. You need to learn this to utilize the microcontroller. So let’s start. ⏱ 6 min read · 🔧 Includes: diagrams & photos, source code Read more
In this chapter, we’ll continue from Chapter 4 which was a practical small project about Learning PIC microcontroller programming in C. So, this chapter also will be a very important part for you to improve your code learning PIC MCU. So follow me with concentration. ⏱ 4 min read · Read more
In this chapter, we’ll learn How to use a microcontroller. Also, we’ll create a basic and simple project that we can start learning with. Besides, we’ll learn how to write block diagrams, and flow charts, How to use Proteus, how to simulate, etc. So let’s begin. ⏱ 9 min read Read more